Hello everyone,

I am looking for a new home server to replace my existing hp proliant microserver gen8.

Requirements:

  1. Reduce power consumption. It currently runs at around 60 watts at idle, I would like to reduce that.

  2. Enough performance for various docker containers

  3. Enough power for 4k HDR video transcoding for a jellyfin container, whether graphics unit in the CPU or an additional graphics card doesn’t matter

  4. At least 4 SATA ports and space for 2 m.2 SSDs

  5. 16GB of RAM is a minimum

It doesn’t have to be a ready-made solution, I have no problem putting everything together myself.

Edit: Budget is ~500€

  • filister@lemmy.world
    link
    fedilink
    English
    arrow-up
    3
    arrow-down
    2
    ·
    1 year ago

    Maybe check some options with Intel N300/305. To be honest I don’t know how good Intel Quicksync is, so you might need an external GPU as well. You also need a power efficient DC PSU at low wattage.

    It is also important what components you put inside, like low-end SSDs have the lowest power consumption and maybe are your best bet. I would also recommend you buying a 5400rpm power efficient HDD if you need it. Disabling all unnecessary ports in the bios can also help lower your power consumption and tweaking the power limits of the C-states, and enabling C10.

    My suggestion is first try to play a bit with your current server BIOS settings and the power optimization in Linux. If your power consumption at full load is like 90-100, maybe consider swapping your current PSU with a DC one, as they have superior power efficiency and after each change evaluate the performance and the power consumption both on idle and on 100%.

    • GerPrimus@feddit.deOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      edit-2
      1 year ago

      Thanks for pointing out the ports, I’ll see which ones can be deactivated. I’ve been reading up on c states lately.I just suspect that my configuration leaves little room for maneuver.The microserver is currently running proxmox with openmediavault and a vial pihole on lxc. I would swap the vial pihole for a raspberry and only use OMV.

      • filister@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        arrow-down
        2
        ·
        1 year ago

        Keep in mind that RPI is good for containers, but not for virtualisation, so if you want to run some VMs or have proper expandability I would advise you against RPI.

        Plus disabling the ports won’t make a big difference I presume, a couple of Watts at best.

        I recently bought an N100 powered firewall appliance and the idle consumption is around 13 Watts, with two SSDs and 32Gb of RAM, a bunch of USB and video ports and 4x2.5Gbps ports all switched on. People are even reporting that this can be pushed down to 7-8W, comparable to what you would get with RPI.

        The i3-N305 has 8 physical cores and TDP of 15Watts, which can easily be reduced to around 9-10.

        • GerPrimus@feddit.deOP
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          Sorry, there was a typo. OMV I would also run the new server and pihole on a raspberry. OMV without the detour via proxmox