I’ve wanted one of these for a while, decided to bite the bullet a couple days ago! Seeing as I was somewhat familiar with CAD software (from engineering classes several years ago) it seemed fairly straightforward.

As someone completely new to this, there have been a TON of things I’ve learned from binging 3d printing channels…

  • First layer adhesion 😭
  • Bed levelling
  • Types of extruders (bowden/direct) and how they affect what materials you can print
  • Tons of printing materials, personally will be using PETG and PLA
  • Keeping filament dry in a vacuum bag

And soo much more - but there is still a lot that I have absolutely no idea about.

The printer is a second-hand Flsun Q5, the seller sent it fully assembled (very, very brave of them, but it arrived unharmed). I had a brief look around at other options, but for the price of an easythreed, this was a no brainer.

I think the seller had some issues with bed adhesion, as there was a ton of slimy stuff on the print bed when it arrived. Used some isopropyl alcohol and a dish sponge to scrub it off, seems all fine now!

I had some issues with the Z-offset but got it good enough to where there is some first layer adhesion.

Model finished printing while I was drafting this post, I sprayed some contact cleaner onto the glass bed to take it off (is that bad?). There’s some stringing:

    • XTL@sopuli.xyz
      link
      fedilink
      arrow-up
      3
      ·
      10 months ago

      I would recommend the round scraper instead. It’s efficient and nice to use and has the maximum amount of usable edge in proportion to footprint.

      Of course you only really need one to lift off skirt or brim or purge lines. Parts should just snap off and if the don’t, scrapes rarely help.

      But anything that keeps fingerprints off the bed and doesn’t scratch it is good.